|
Brand: MEC-DIESEL |
Code: MEC190830 |
Title: Oil Sump
Oil Sump - MEC190830 MEC-DIESEL - 038103601AQ, 038103601MA, 038103603M
Car: ŠKODA-VW
Unfortunately, there is no additional description available for this product.
Used in
No link to the structure of cars and engines defined.
Reference Numbers
- VW # 038 103 601AQ
- AUDI # 038 103 601AQ
- SEAT # 038103601AQ
- SKODA # 038103601AQ
- VW # 038 103 601MA
- AUDI # 038 103 601MA
- SKODA # 038103601MA
- SKODA # 038103603M
- BLIC # 0216007520470P
- MEC-DIESEL # 5136
- KLOKKERHOLM # 7520470
- STOP&GO # QD-VW-163
- 038103601AQ
- 038103601H
- 038103601MA
- MEC-DIESEL # 190830
Alternatives
General information
| Code: | V10-0426 |
| Brand: | VAICO |
| Title: | Oil Sump |
| Car: | ŠKODA-VW |
| Weight : | 0,00 kg |
Criteria
| Width [mm]: | 280,0 mm |
| Supplementary Article/Info 2: | with seal ring |
| Observe the vehicle manufacturer specifications: | yes |
| Height [mm]: | 125 mm |
| Section: | Lower Section |
| Supplementary Article/Supplementary Info: | with oil drain plug |
| Supplementary Article/Info 2: | without oil sump gasket |
| See accessories list for additionally required parts: | yes |
| Forward- /Backflow: | with backflow |
| Oil Sump Material: | Aluminium |
| Observe system fill quantity: | yes |
| Length [mm]: | 430 mm |
| Supplementary Article/Info 2: | without bore for oil level sensor |
| Weight [kg]: | 2,881 kg |
| General Information: | Products supplied by us are without exception intended for the designated use. Please note that our products are usually delivered without installation instructions. Installation may only be carried out by trained specialist personnel. There is no guarantee for inappropriate, improper or unintended use. |
| General Information: | In the warranty, we always make a distinction between wear parts and vehicle parts. All wear parts are subject to a reduced warranty period and a maximum mileage. Brake components such as brake disks, brake pads, etc. maximum of 1000 km (break-in period). Therefore, warranty claims for brake parts are only reviewed with an installation invoice and a record of the wheel hub run-out measurement, including photos. For brake disks and brake pads, the break-in requirements specified by the vehicle manufacturer must be observed. When replacing brakes, the chassis components must always be checked with regard to clearance and the wheel hub with regard to wobble, and the appropriate documentation must be produced. If the vehicle is no longer in its original condition due to tuning work such as wheel accessories and tracking plates, the entitlement to make warranty claims is lost due to third-party work. The same warranty claims are lost if the vehicle is used for motor sports or similar events. |
Show all
Show less